Tool Training: Electronics
In-person at InterAccess (32 Lisgar) - Register here
Registration Fee: FREE Member | $25 Non-Member
This hands-on training session will introduce members to the electronics tools available in the InterAccess studio.
In this 3-hour session, participants will learn:
- What tools and components are available to use
- How to operate the soldering irons and hot air rework station properly and safely
- Best practices for using the electronics bench in the InterAccess studio
Tool Training sessions are designed for InterAccess members to learn how to operate the studio equipment safely and independently. These sessions are available at no cost to Studio Members. Non-members, including those looking to access equipment during Open Studio, can register to receive this training for a $25 fee.
After this training, members will be approved to use the soldering irons and/or hot air rework station.
About the Trainer
This training will be led by InterAccess Studio Assistant Alison Clark.
Accessibility Information: We are located on the second floor of the building, which is accessible by two flights of stairs or an elevator. The front entrance has an automatic push door and is accessible by ramp or a short flight of stairs. Inside, all InterAccess facilities are on the same level, including a single-user accessible washroom.
Questions? If you have any questions about the workshop or special requirements, please contact us at education@interaccess.org.
Cancellation and Rescheduling Policy: We are unable to guarantee attendee cancellations or refunds less than 1 week prior to a workshop or event. InterAccess reserves the right to cancel or reschedule this workshop if necessary. Please email education@interaccess.org to request a refund.